Event ID - ASA-3-114008

Message CodeASA-3-114008
SeverityError
DescriptionFailed to enable port after link is up in 4GE SSM I/O card due to either I2C serial bus access error or switch access error.
ExplanationThis message is displayed when the system fails to enable a port after the link transition to Up state is detected in an 4GE SSM I/O card due to either an I2C serial bus access error or a switch access error.
syslog_id—Message identifier
error_string—Describes either an I2C serial bus error or a switch access error, which is a decimal
error code. The following are the I2C serial bus errors:
• I2C_BUS_TRANSACTION_ERROR
• I2C_CHKSUM_ERROR
• I2C_TIMEOUT_ERROR
• I2C_BUS_COLLISION_ERROR
• I2C_HOST_BUSY_ERROR
• I2C_UNPOPULATED_ERROR
• I2C_SMBUS_UNSUPPORT
• I2C_BYTE_COUNT_ERROR
• I2C_DATA_PTR_ERROR
User ActionPerform the following steps:
1. Log and review the messages and the errors associated with the event.
2. Reboot the software running on the system.
3. Power cycle the box. When you turn off the power, make sure you wait several seconds before turning the power on.
4. If the problem persists, contact Cisco TAC.
Reference Links

Catch threats immediately

We work side-by-side with you to rapidly detect cyberthreats
and thwart attacks before they cause damage.

See what we caught

Did this information help you to resolve the problem?

Yes: My problem was resolved.
No: The information was not helpful / Partially helpful.