| Event Id | 4188 |
| Source | cpqasm |
| Description | The Compaq System Management Driver has detected that the system encountered an NT bugcheck prior to this boot. The bugcheck data was: STOP: 0x000000D1 (0x00000004, 0x00000008, 0x00000000, 0xBFF69101). |
| Event Information | According to Microsoft: This error message can occur if either of the following conditions exists: 1. Your computer has hardware or software problems (hardware failure is the most common cause). 2. You try to over clock the speed of your computers processor (for example, you set a 150 MhZ processor to run at 187 MhZ). The above STOP error means a trap occurred in kernel mode and the trap is either one the kernel is not allowed to have or is always fatal. The most common causes of a STOP 0x7F are: 1. Low-level hardware corruption, such as corrupt memory (RAM) 2. Mismatched memory modules. 3. A malfunctioning motherboard. |
| Reference Links | General Causes of STOP 0x0000007F Errors STOP 0x4E, STOP 0x1A, STOP 0x50, and STOP 0xA Errors Occur When You Try to Start the Computer |
Catch threats immediately
We work side-by-side with you to rapidly detect cyberthreats
and thwart attacks before they cause damage.