Event ID - 30051

Event Id30051
SourceMicrosoft-Windows-RasRoutingProtocols-IPRIP2
DescriptionIPRIPv2 could not request multicasting on the local interface with IP address: %1. The data is the error code.
Event Information According to Microsoft:

Resolution :

Check memory, restart Routing and Remote Access service, check TCP/IP settings, or reinstall RIP
Possible resolutions:
  • This computer might be low on memory.
  • Stop and restart the Routing and Remote Access service.
  • Check TCP/IP settings. Use the netstat -a command to show the status of all activity on TCP and UDP ports on the local computer.
  • Remove and reinstall RIP.

To perform these procedures, you must be a member of the Administrators group, or you must have been delegated the appropriate authority.
Check memory usage on the server
To check memory usage on the remote access server:
  1. On the remote access server, click Start , click Run , type taskmgr , and then click OK .
  2. In the Windows Task Manager dialog box, click the Performance tab.
  3. Under Physical Memory , check the remote access server's memory usage.
  4. If necessary, free up available memory by ending non-essential applications or processes.
Restart the remote access service
To restart the remote access service:
  1. Open Routing and Remote Access. Click Start , click Run , type rrasmgmt.msc , and then press ENTER.
  2. By default, the local computer is listed as a server. To add another server, in the console tree, right-click Server Status , and then click Add Server . In the Add Server dialog box, click the appropriate option, and then click OK.
  3. In the console tree, right-click the server you want to restart, click All Tasks , and then click Restart .
    Remove and reinstall RIP
    To remove and reinstall RIP:
    1. Open Routing and Remote Access. Click Start , click Run , type rrasmgmt.msc , and then press ENTER.
    2. In the console tree, expand IPv4 , right-click RIP , and then click Delete .
    3. 3.Click Yes in the confirmation dialog box.
    4. Under IPv4 , right-click General , and then click New Routing Protocol .
    5. Click RIP Version 2 for Internet Protocol , and then click OK .
    6. Under IPv4 , right-click RIP , and then click New Interface .
    7. Click the interface for RIP, and then click OK .
    8. Modify the settings in the RIP properties dialog box, and then click OK
    .
    Verify :
    To perform this procedure, you must have membership in Administrators , or you must have been delegated the appropriate authority.
    To verify that the Routing Table Manager (RTM) route has been added:
    • Stop and restart the Routing and Remote Access service.
      1. Click Start , click Run , type rrasmgmt.msc , and then press ENTER.
      2. 2.Open Routing and Remote Access.
      3. In the console tree, click Server Status .
  4. In the details pane, right-click a server name, point to All Tasks , and click Restart.
  5. View the routing table. In the Routing and Remote Access snap-in, expand IPv4 or IPv6 , right-click Static Routes , and then click Show IP Routing Table .
  6. Verify that the route has been added.
Reference LinksEvent ID 30051 from Source Microsoft-Windows-RasRoutingProtocols-IPRIP2

Catch threats immediately

We work side-by-side with you to rapidly detect cyberthreats
and thwart attacks before they cause damage.

See what we caught

Did this information help you to resolve the problem?

Yes: My problem was resolved.
No: The information was not helpful / Partially helpful.