Event ID - 10038

Event Id10038
SourceISA Server Firewall service
DescriptionSoftware caused connection to abort. For more information about this event, see ISA Server Help.
Event InformationAccording to Microsoft:
Cause:

This error can occur when the local network system aborts a connection, such as when WinSock closes an established connection after data retransmission fails (receiver never acknowledges data sent on a datastream socket).
Resolution:
Exit the application, restart and try to reconnect. You can also check the following:
1. Ping the remote host you were connected to. If it does not respond, it might be off-line or there might be a network problem along the way. If it does respond, then this problem might have been a transient one (so you can reconnect now), or the server application you were connected to might have terminated (so you might not be able to connect again).
2. Ping a local host to verify that your local network is still functioning (if on a serial connection, see next step)
3. Ping your local router address. If you are on a serial connection, your local router is the IP address of the host you initially logged on to using SLIP or PPP.
4. Ping a host on the same subnet as the host you were connected to (if you know of one). This will verify that the destination network is functioning.
5. Use the tracert command at the command prompt to determine the path to the host you were connected to. This wont reveal too much unless you know the router addresses at the remote end, but it might help to identify if the problem is somewhere along the way.
Reference LinksSoftware caused connection to abort

Catch threats immediately

We work side-by-side with you to rapidly detect cyberthreats
and thwart attacks before they cause damage.

See what we caught

Did this information help you to resolve the problem?

Yes: My problem was resolved.
No: The information was not helpful / Partially helpful.