| Event Information | According to Microsoft :
Cause :
This event is logged when DHCPV6 Relay Agent detected an error on the local interface with IP address.
Resolution :
Reinstall the DHCPv6 Relay Agent, check memory status, restart Routing and Remote Access service
Possible resolutions: - Reconfigure the DHCPV6 Relay Agent to request notification of events on the socket for the local interface and to relay a DHCP REPLY packet on the local interface. For more information, see the "Configure DHCPv6 Relay Agent" section.
- Disable and enable the interface and then confirm it is running.
- Remove and reinstall the DHCPv6 Relay Agent. For more information, see the "Remove and reinstall the DHCPv6 Relay Agent" section.
- This computer might be low on memory. For more information, see the "Check memory usage on the server" section.
- Stop and restart the Routing and Remote Access service. For more information, see the "Restart the remote access service" section.
- Restart the computer.
To perform these procedures, you must have membership in Administrators , or you must have been delegated the appropriate authority.
Configure the DHCPv6 Relay Agent
To configure the DHCPv6 Relay Agent: - Open Routing and Remote Access. Click Start , click Run , type rrasmgmt.msc , and then press ENTER.
- In the console tree, expand IPv6 , and then click DHCPv6 Relay Agent .
- In the details pane, right-click the interface you want to configure, and then click Properties .
- Check that Relay DHCP packets is enabled.
Remove and reinstall the DHCPv6 Relay Agent
To remove and reinstall the DHCPv6 Relay Agent: - Open Routing and Remote Access. Click Start , click Run , type rrasmgmt.msc , and then press ENTER.
- In the console tree, expand IPv6 , right-click DHCPv6 Relay Agent , and then click Delete .
- Click Yes to confirm the deletion.
- Under IPv6 , right-click General , and then click New Routing Protocol .
- Click DHCPv6 Relay Agent , and then click OK .
Check memory usage on the server
To check memory usage on the remote access server: - On the remote access server, click Start , click Run , type taskmgr , and then click OK .
- In the Windows Task Manager dialog box, click the Performance tab.
- Under Physical Memory , check the remote access server's memory usage.
- If necessary, free up available memory by ending nonessential applications or processes.
Restart the remote access service
To restart the remote access service: - Open Routing and Remote Access. Click Start , click Run , type rrasmgmt.msc , and then press ENTER.
- By default, the local computer is listed as a server. To add another server, in the console tree, right-click Server Status , and then click Add Server . In the Add Server dialog box, click the appropriate option, and then click OK .
- In the console tree, right-click the server you want to restart, click All Tasks , and then click Restart .
Verify :
To verify that the DHCPv6 Relay Agent is working:
From the router with the DHCPv6 Relay Agent enabled, use the ping command to ping each of the DHCPv6 servers that are configured in the DHCPv6 Relay Agent dialog box on the remote access server. |