Event ID - 30025

Event Id30025
SourceMicrosoft-Windows-RasIpBootp
DescriptionIPBOOTP could not schedule the processing of a packet received on the local interface with IP address: %1. The packet was received from a machine with IP address: %2. This error may have been caused by a memory allocation failure.The data is the error code.
Event Information According to Microsoft :

Cause :
This event is logged when IPBOOTP could not schedule the processing of a packet received on the local interface.

Resolution :

Check memory status, reinstall DHCP Relay Agent, or configure DHCP Relay Agent hop count

Possible resolutions:
  • This computer might be low on memory. For more information, see the "Check memory usage on the server" section.
  • Remove and reinstall the DHCP Relay Agent. For more information, see the "Remove and reinstall the DHCP Relay Agent" section.
  • Check that the hop count field is correctly configured. For more information, see the "Configure DHCP Relay Agent hop count" section.
To perform these procedures, you must have membership in Administrators , or you must have been delegated the appropriate authority.

Check memory usage on the server

To check memory usage on the remote access server:
  1. On the remote access server, click Start , click Run , type taskmgr , and then click OK .
  2. In the Windows Task Manager dialog box, click the Performance tab.
  3. Under Physical Memory , check the remote access server's memory usage.
  4. If necessary, free up available memory by ending non-essential applications or processes.
Remove and reinstall DHCP Relay Agent

To remove and add the DHCP Relay Agent:
  1. Open Routing and Remote Access. Click Start , click Run , type rrasmgmt.msc , and then press ENTER.
  2. In the console tree, expand IPv4 , right-click DHCP Relay Agent , and then click Delete .
  3. Click Yes to confirm the deletion.
  4. Under IPv4 , right-click General , and then click New Routing Protocol .
  5. Click DHCP Relay Agent , and then click OK.
Configure DHCP Relay Agent hop count

To configure DHCP Relay Agent hop count:
  1. Open Routing and Remote Access. Click Start , click Run , type rrasmgmt.msc , and then press ENTER.
  2. In the console tree, expand IPv4 , and then click DHCP Relay Agent .
  3. In the details pane, right-click the interface you want to configure, and then click Properties .
  4. Check the settings in the Hop-count threshold field.
Verify :

To verify that the DHCP Relay Agent is working:
From the router with the DHCP Relay Agent enabled, use the ping command to ping each of the DHCP servers that are configured in the DHCP Relay Agent dialog box on the remote access server.
Reference LinksEvent ID 30025 from Source Microsoft-Windows-RasIpBootp

Catch threats immediately

We work side-by-side with you to rapidly detect cyberthreats
and thwart attacks before they cause damage.

See what we caught

Did this information help you to resolve the problem?

Yes: My problem was resolved.
No: The information was not helpful / Partially helpful.
 Refresh