Event ID - 20174

Event Id20174
SourceRemoteAccess
DescriptionPossible leaky multicast local scope detected between this machine and: %1, since a boundary appears to exist for: %2, but not for the local scope. If this warning continues to occur, a problem likely exists.
Event Information According to Microsoft :

Cause :

This event is logged when possible leaky multicast local scope detected between this machine.

Resolution :

Configure multicast scope, boundaries, or heartbeat

To perform these procedures, you must have membership in Administrators, or you must have been delegated the appropriate authority.

Follow the procedures in the order in which they appear until the problem is resolved.

Configure multicast scopes

To configure multicast scopes:

A scope is a range of IP multicast addresses and is defined by specifying the address range as an IP address and mask. Multicast addresses in the range of 239.0.0.0 to 239.255.255.255 (239.0.0.0/8) are used to specify administrative scopes, as defined in RFC 2365. However, the range of 239.255.0.0/16 is defined as a local scope and cannot be divided further.
  1. Open Routing and Remote Access. Click Start , click Run , type rrasmgmt.msc , and then press ENTER.
  2. In the console tree, double-click the server name.
  3. Double-click IPv4 , right-click General , and then click Properties .
  4. On the Multicast Scopes tab, click a multicast scope, and then click Edit .
  5. Review the settings, and then add or delete the scope, as appropriate.
Configure multicast boundaries

To configure multicast boundaries:

Multicast boundaries are administrative barriers that can be configured to limit how far routers can forward multicast traffic across a network. Without boundaries, a multicast router forwards all multicast traffic throughout the network. With boundaries, a multicast router forwards multicast traffic over a limited area of the network only.
  1. Open Routing and Remote Access. Click Start , click Run , type rrasmgmt.msc , and then press ENTER.
  2. In the console tree, double-click the server name.
  3. Double-click IPv4 ,and then click General .
  4. In the details pane, right-click the interface on which you want to configure multicast boundaries, and then click Properties .
  5. On the Multicast Boundaries tab, review the scope boundary settings.
Note : Only scopes configured as multicast scopes are listed in Scope .

Configure multicast heartbeat

To configure multicast heartbeat:

Multicast heartbeat is the ability of a server running Routing and Remote Access to listen for a regular multicast notification to a specified group address to verify that IP multicast connectivity is available on the network. If the heartbeat is not received within a configured amount of time, the server running Routing and Remote Access sets the multicast heartbeat status of the configured interface to inactive.
  1. Open Routing and Remote Access. Click Start , click Run , type rrasmgmt.msc , and then press ENTER.
  2. In the console tree, double-click the server name.
  3. Double-click IPv4 ,and then click General .
  4. In the details pane, right-click the interface on which you want to configure multicast boundaries, and then click Properties .
  5. On the Multicast Heartbeat tab, select the Enable multicast heartbeat detection check box.
  6. Add a multicast heartbeat group, and configure a quiet time.
Verify :

To verify that multicast traffic is being forwarded to the multicast group address, on a receiving host, open a multicast-enabled application and verify streaming content is being received.
Reference LinksEvent ID 20174 from RemoteAccess

Catch threats immediately

We work side-by-side with you to rapidly detect cyberthreats
and thwart attacks before they cause damage.

See what we caught

Did this information help you to resolve the problem?

Yes: My problem was resolved.
No: The information was not helpful / Partially helpful.
 Refresh